DC Power Jack for Dell Latitude 5500 and similar models

Tutorial: How to Replace the DC Power Jack in Dell Latitude 5500, Latitude 5501, Latitude 5510, Latitude 5511 – W3P6G, 0W3P6G

Il ricambio di questa guida

Spedizione gratuita in 1-4 giorni · Spedizione da Germania, Italia e Francia · Garanzia 2 anni

This step-by-step guide shows how to replace the DC power jack in your Dell Latitude 5500 and similar models. Set aside some time, work on a clean surface and check the part number first.

✅ View the replacement part: W3P6G, 0W3P6G

Symptoms that point to this part

  • The laptop charges only when the plug is held at an angle
  • The charging light flickers or stays off
  • The plug feels loose in the port
  • The laptop runs on battery although the charger works

Compatible models

  • Dell Latitude 5500
  • Dell Latitude 5501
  • Dell Latitude 5510
  • Dell Latitude 5511
  • Dell Precision 3540
  • Dell Precision 3541
  • Dell Precision 3550
  • Dell Precision 3551

Part number: W3P6G, 0W3P6G
Model: EDC50, DC301013900

Laptops with the same model name can have different internal versions. Compare the part number and connector on your old part with the product photos before ordering.

⚠️ Before you start

This repair involves opening your laptop and may void any remaining manufacturer warranty. Screw positions and access differ between versions, so follow your model's service manual where it differs from this guide. Proceed only if you are comfortable working with static-sensitive electronics.

🧰 Tools and materials

  • Phillips screwdriver (PH0 or PH1)
  • Plastic spudger or opening pick
  • Replacement DC power jack: W3P6G, 0W3P6G
  • Anti-static wrist strap (recommended)

🔌 1. Power off and unplug

  • Shut the laptop down completely.
  • Disconnect the charger and all connected devices.
  • Hold the power button for a few seconds to discharge remaining power.

📦 2. Remove the bottom cover

  • Place the laptop upside down on a soft surface.
  • Remove all screws from the bottom panel. Some may be hidden under rubber feet.
  • Release the cover carefully with a plastic tool.

🔧 3. Disconnect the battery

  • Unplug the battery connector from the motherboard before touching the jack.

DC Power Jack for Dell Latitude 5500 and similar models

🔧 4. Remove the old jack

  • Locate the jack at the edge of the case.
  • Unplug its cable from the motherboard, then remove the screw or bracket holding the jack.
  • Lift the jack out and note how the cable is routed.

🔧 5. Install the new jack

  • Seat the new jack in the same position and fit the bracket or screw.
  • Route the cable the same way and plug it into the motherboard.
  • Reconnect the battery.

🧩 6. Reassemble the laptop

  • Fit the bottom cover back and tighten all screws.
  • Reconnect anything you removed.

⚙️ 7. Test the repair

  • Connect the charger and power on the laptop.
  • Plug in the charger and confirm that the battery charges without moving the plug.

Frequently asked questions

How do I know this part fits my laptop?

Match the part number printed on your old part and compare the product photos. The model name alone is not always enough.

Is it always the jack?

No. Try a known-good charger first. If the plug sits firmly and nothing changes, the fault may be on the motherboard.

🎉 Done!

Your Dell Latitude 5500 and similar models should be working properly again. Need the part? Order the DC power jack here. It comes with a 6-month warranty.

Ricambi per questa riparazione

Spedizione gratuita in 1-4 giorni · Spedizione da Germania, Italia e Francia · Garanzia 2 anni

Torna al blog