This step-by-step guide shows how to replace the CPU and GPU cooling fans in your Dell Inspiron 15 7510 and similar models. Set aside some time, work on a clean surface and check the part number first.
✅ View the replacement part: CNNWF, 0CNNWF, GJN2R
Symptoms that point to this part
- Loud grinding, rattling or clicking noise from one or both fans
- The laptop overheats or throttles in games and heavy applications
- Fan error at boot, or a fan that no longer spins
- Sudden shutdowns under load
Compatible models
- Dell Inspiron 15 7510
- Dell Inspiron 16 7610 with 2 coolers equipped with GPU Intel UHD Graphics, Nvidia GTX 1650, Nvidia RTX 3050, or Nvidia RTX 3050 Ti
Part number: CNNWF 0CNNWF GJN2R 0GJN2R
Model: B8906ASHNF20000TN, 023.100NF.0011 B6506ASHNF20000TN, 023.100NG.0011
Laptops with the same model name can have different internal versions. Compare the part number and connector on your old part with the product photos before ordering.
⚠️ Before you start
This repair involves opening your laptop and may void any remaining manufacturer warranty. Screw positions and access differ between versions, so follow your model's service manual where it differs from this guide. Proceed only if you are comfortable working with static-sensitive electronics.
🧰 Tools and materials
- Phillips screwdriver (PH0 or PH1)
- Plastic spudger or opening pick
- Thermal paste and isopropyl alcohol, if the heatsink must be removed
- Replacement CPU and GPU cooling fans: CNNWF, 0CNNWF, GJN2R
- Anti-static wrist strap (recommended)
🔌 1. Power off and unplug
- Shut the laptop down completely.
- Disconnect the charger and all connected devices.
- Hold the power button for a few seconds to discharge remaining power.
📦 2. Remove the bottom cover
- Place the laptop upside down on a soft surface.
- Remove all screws from the bottom panel. Some may be hidden under rubber feet.
- Release the cover carefully with a plastic tool.
🔧 3. Locate both fans
- Find the two fans at the rear of the laptop, one on each side of the heatsink.
- Remove any cable or antenna routed over the fans, and note how it is routed.

🔧 4. Disconnect and remove the old fans
- Unplug both fan connectors from the motherboard, pulling on the plastic connector and not on the wires.
- Remove the fan screws and lift each fan out. Keep track of which screw goes where.
🔧 5. Install the new fans
- Check the left and right fan against the old ones before fitting them. The two are not interchangeable.
- Fit each fan, tighten its screws and plug in its connector.
🧩 6. Reassemble the laptop
- Fit the bottom cover back and tighten all screws.
- Reconnect anything you removed.
⚙️ 7. Test the repair
- Connect the charger and power on the laptop.
- Check that both fans spin up under load and that temperatures drop.
Frequently asked questions
How do I know this part fits my laptop?
Match the part number printed on your old part and compare the product photos. The model name alone is not always enough.
Do I have to replace both fans?
Only if both are worn or the set is what you need. They usually age at the same rate, so replacing them together saves a second disassembly.
Do I need new thermal paste?
Only if you remove the heatsink from the processor. If you take out just the fan, the paste stays undisturbed.
🎉 Done!
Your Dell Inspiron 15 7510 and similar models should be working properly again. Need the part? Order the CPU and GPU cooling fans here. It comes with a 6-month warranty.
