Here’s a step-by-step tutorial on how to replace the HDD/SSD SATA cable and metal caddy in HP ProBook using compatible part numbers like:
🔧 How to Replace the HDD/SSD Cable and Caddy in HP ProBook (450 G6 455 G6 455R G6)
⚠️ Disclaimer
This repair involves opening your laptop and handling delicate connectors. Proceed carefully and avoid pulling or bending the SATA cable or damaging the drive connectors.
🧰 Tools and Materials Needed
Phillips screwdriver (PH0 or PH1)
Plastic spudger or pry tool (optional)
Replacement HDD/SSD SATA cable and caddy set: L45094-001 DD0X8KHD010
Anti-static wrist strap (recommended)
🔌 1. Power Off and Unplug
Shut down the laptop completely.
Disconnect the charger and all external devices.
Hold the power button for 5–10 seconds to discharge remaining power.
📦 2. Remove the Bottom Cover
Place the laptop upside down on a soft surface.
Remove all screws securing the bottom panel.
Carefully pry up and remove the bottom cover.
🔋 3. Disconnect the Battery
Locate the internal battery connector on the motherboard.
Gently disconnect it to prevent short circuits while working inside the system.
💽 4. Locate the HDD/SSD Bay
The HDD/SSD bay is typically located along one side of the chassis.
If an old drive is already installed, remove it along with its caddy and cable.
🧱 5. Remove the Old Drive, Cable, and Caddy Assembly
Unscrew the mounting screws holding the drive caddy in place.
Carefully lift the drive assembly from the bay.
Disconnect the SATA cable from the motherboard.
Detach the cable from the drive and separate the caddy from the drive by removing the small side screws.
🔁 6. Install the New Cable and Caddy Set
Attach the new SATA cable to the new caddy.
Mount your HDD or SSD into the caddy and secure it using the small side screws.
Connect the SATA cable to the drive.
Re-route the flat SATA cable carefully through the same path or guide clips as the original one to ensure proper fit and avoid pinching.
Connect the other end of the SATA cable to the motherboard port securely.
Seat the new drive and caddy assembly into the bay and fasten the mounting screws.
🧩 7. Reassemble the Laptop
Reconnect the battery.
Reinstall the bottom cover and secure all screws.
⚙️ 8. Test the System
Plug in the power adapter and turn on the laptop.
Enter BIOS (press F2 at startup) to confirm that the new drive is detected.
If recognized, proceed with your operating system installation or data transfer.
🎉 Done!
You’ve successfully replaced the HDD/SSD SATA cable and caddy in your HP ProBook. Your new drive should now be properly secured and connected for optimal performance.